started knee cap added divisions to belt etc.

started belt armour and added shoulder detail

for the next days ill just focus on trying to make more armour I need to make the back piece of the belt that goes over the butt., chest, gauntlets, knee cap, leg or thigh piece etc, jetpack 

shoulder piece and updates I hadn't posted.@Alan

 

So I have been trying to model a really basic shoulder piece but it needs a lot of work, it doesn't have all the detail I plan on doing tomorrow.. and I'm not sure on things and there is a question of how accurate I want or need the amor to be for example I really wanna make my armor look pre heresy Iron Warrior and I think its important to refer to my miniatures rather than just my ortho as I could make the design better I don't think the ortho is enough to do it justice. I was going to try and get the armor pieces modelled so that they were available? I re-did the string for the balloon did the same things like taper but I used a cylinder as it made more sense.

Balloon knot, string, and Brush, bolter grip re done@Alan

Cv curve square extrude along divisions to match curve and then twist and taper so it goes smaller one end. and I latticed deformed the other part to get it not exactly like a cone and extruded in etcalso torus for the knot.

This ok now? also added more edge loops less stretched. also made the brush tip out of cylinder etc.

Fine detail paint brush citadel and started balloon@Alan

I think the brush needs to changed somehow it doesn't look right.

I think the rest is ok?

The balloon is bewildering me on how you would do the string and the tied up part also if it needs to pop and fly upward's it would need physics? I don't know if that is something I should be worried about yet though, probably just the model.

After these prop's are completed I can focus on making a character.

Cake prop and citadel paint pot @Alan

So I re-did the cake and I then tried to do the paint pot I think it's ok? the part that is probably the main concern is the hinge part as I struggled with that bit..

Bottom of cake topper and extra detail bolter@Alan

Cake toppers:

•  this bottom part for the cake topper correct now? I tried to do what was at the top of the model?
• The female one I was just going to do as a duplicate and maybe just change the bottom to look more like a dress if not just keep it the exact same?

Boltor

• Also I have saved a separate file from the boltor before and just changed some details to try and get it to look better but I just wondered if it was a good idea to have the hand grip on the front or not I think its quite a key detail so I thought I should atleast try to do it as I think it would look really good.?

•  I did try to do the part on the base of the gun that is kind of extruded outa bit but that got messy and complicated so I left it for now..as I don't know whether to model it or just be textured?
• However I think this may have solved the issue of the front hand grip kind of having that gap between the gun, but I'm not sure on the best way to achieve this.

• The front hand grip has the top faces would I get rid of them like last time?.

I don't want to get too caught up on the model but I do want it to be improved if it is worth it.

If its better to just use the model without the front piece so pretty much the same as before with very little change ill do that.

the rest of the things I did were tiny for example I added the little rectangle at the front and added bolts changed the top bit to just one long square. Already had those shapes on the model or were simple enough to do.